2022 Ford Mustang Mach-E Exterior Lighting Control Guide

by
Contents hide
1 EXTERIOR LIGHTING CONTROL
2 USING THE HIGH BEAM HEADLAMPS
3 SWITCHING HEADLAMP EXIT DELAY ON AND OFF
4 HEADLAMP INDICATORS
5 HEADLAMPS – FREQUENTLY ASKED QUESTIONS
6 WHAT ARE AUTOLAMPS
7 AUTOLAMP SETTINGS

EXTERIOR LIGHTING CONTROL

2022 Ford Mustang Mach-E Exterior Lighting Control Guide
ALamps off.
BParking lamps on.
CAutolamps on.
DHeadlamps on.

Rotate the control to make a selection.

Note:   The lighting control defaults to autolamps every time you switch your vehicle on.

USING THE HIGH BEAM HEADLAMPS

2022 Ford Mustang Mach-E Exterior Lighting Control Guide High Beam Switch

High Beam Indicator  Push the lever away from you to switch the high beams on.

Push the lever forward again or pull the lever toward you to switch the high beams off.

Slightly pull the lever toward you and release it to flash the headlamps.

Note:   Continuous activation only with headlamps on.

SWITCHING HEADLAMP EXIT DELAY ON AND OFF

To switch the headlamp exit delay on, pull the turn signal lever toward you after switching your vehicle off.

To switch headlamp exit delay-off, pull the turn signal lever toward you again or switch your vehicle on.

Note:   The headlamps turn off after three minutes with any door open or 30 seconds after the last door closes.

HEADLAMP INDICATORS

Lamps On

Lamps ON Indicator  Illuminates when you switch the low beam headlamps or the parking lamps on.

Headlamp High Beam

High Beam Indicator  Illuminates when you switch the high beam headlamps on.

HEADLAMPS – FREQUENTLY ASKED QUESTIONS

Why is there condensation in the headlamps?

  • Headlamps have vents to accommodate normal changes in air pressure. Condensation can be a natural by-product of this design. When moist air enters the lamp assembly through the vents, there is a possibility that condensation can occur when the temperature is cold. When normal condensation occurs, a fine mist can form on the interior of the lens. The fine mist eventually clears and exits through the vents during normal operation.

How much condensation is acceptable?

  • The presence of a fine mist, for example, no streaks, drip marks or large droplets. A fine mist covers less than 50% of the lens.

How long may it take for the acceptable condensation to be cleared?

  • Clearing time may take as long as 48 hours under dry weather conditions.

How much condensation is unacceptable?

  • A water puddle inside the lamp. Streaks, drip marks, or large droplets are present on the interior of the lens.

What should I do if unacceptable condensation is present?

  • Have your vehicle checked as soon as possible.

Why do my headlamps turn off when I have them switched on when I switch my vehicle off?

  • The battery saver turns the headlamps off after a short period of time after you switch your vehicle off.

WHAT ARE AUTOLAMPS

WARNING   WARNING:  The system does not relieve you of your responsibility to drive with due care and attention. You may need to override the system if it does not turn the headlamps on in low visibility conditions, for example, daytime fog.

Autolamps turn the headlamps on in low-light situations or when the windshield wipers operate.

AUTOLAMP SETTINGS

  1. Access the vehicle drawer on the touchscreen.
  2. Press SETTINGS.
  3. Press Vehicle.
  4. Press Lighting.
  5. Press Autolamp Delay.
  6. Press a setting.

For more detailed information, please reference the 2022 Ford Mustang Mach-E Owner’s Manual.